€ 54.99
Sin Impuesto: € 45.45
Descripción
Vigila tus entradas 24/7, puede detectar cuando una puerta o ventana ha sido abierta. Podrás controlar si tu alarma está armada, control de luces y sirenas, y enviar notificaciones a tu telefono móvil.
Este sensor está diseñado para ser prácticamente invisible, se coloca en la esquina de una puerta o ventana y puede ser pintado del color o tono de la misma. Es un 50% más fino que sus competidores, tiene sólo 9 mm de profundidad y 72 mm desde el eje.
Pese a su pequeño tamaño, es un sensor muy preciso. Posee dos interruptores magnéticos a lo largo de su borde, estos comunican con un fino imán de sólo 2 mm y que se puede colocar hasta 2.2 cm de distancia.
Está fabricado con plástico ABS, y se compone de tres partes: El sensor, una placa de montaje y una fina banda magnética.
Además lleva una batería recargable que aguanta más de un año y 10 meses en puertas de uso frecuente. Cuando se agota la batería sólo tienes que quitar el sensor de su placa de montaje y recargarlo a través de su puerto USB durante unas pocas horas.
CARACTERÍSTICAS:
- Dimensiones: 9 x 72 mm.
- Pintable para una instalación invisible.
- Fabricado con plástico ABS.
- Recargable batería Li-ion con 500 mAh de capacidad.
- Tecnología Z-Wave serie 500.
- Notificaciones de batería baja.
- Hasta 150 m de alcance punto a punto.
Especificaciones
Compatibilidad Controlador Principal | |
---|---|
eeDomus+ | Full Compatible |
Fibaro Home Center 2 v4.160 | Full Compatible |
Fibaro Home Center Lite v.4.160 | Full Compatible |
Vera Edge / Plus / Secure | Not Tested |
Zipabox/Zipaminicro/ZipaTile | Full Compatible |
Piper / Piper NV (v.1.7.1) | Not Tested |
Indigo | Not Tested |
jeedom | Full Compatible |
Z-Wave.me / Z-Way / PoPP Hub v 3.2.1 | Not Tested |
ZiHome | Not Tested |
Tech Data | |
IP Rating | IP 20 (Indoor use only) |
Alimentación | Power supply: Rechargeable Lithium battery, 3.7 V, 500mAh. Battery charger input: Micro USB port, DC 5V±0.5V, max 1A. |
FLiRS | No |
Explorer Frames - NWI Support | No |
SDK | 6.51.06 |
Device Type | Notification Sensor |
Z-Wave Alliance Product Link | http://products.z-wavealliance.org/products/1615 |
Routing | No |
Procedimientos | |
Inclusión | Turn the primary controller into inclusion mode, short press the product's Action Button that you can find in the back of the product. |
Exclusión | Turn the primary controller into exclusion mode, short press the product's Action Button that you can find in back of the product. |
Factory Reset | Press the Action Button once that you can find in the back of the product for 20 seconds and then release. This procedure should only be used when the primary controller is inoperable. |
Wake-up (despertar) | Press the Action Button once, which will trigger sending out the Wake up notification command, press and hold the Action Button for 3 seconds, which will toggle on/off the Sensor be waked up for 10 minutes. |