€ 34.99
Sin Impuesto: € 28.92
Descripción
El pequeño y discreto sensor alimentado por batería podría instalarse tanto en el suelo como en la pared debido a su construcción compacta. Detencion precisa de la presencia y también la ausencia de agua. Incluido en una red Z-Wave, el detector de inundacion Hank, envía notificaciones y activa alertas. Para evitar daños costosos en su vivienda domotica
Caracteristicas:
- El sensor de inundación detecta la presencia y la ausencia de agua
- Soporte de pared incluido y sonda de inundacion cableada incluida
- Sensor de temperatura y vibración integrado
- Construcción compacta con fácil instalación en el suelo y en la pared
- Alerta de batería baja
- No incluye alarma acustical
- Fuente de alimentación: batería 1x (ER14250)
- Duración de la batería: 1 año
- Tecnología inalámbrica: Z-Wave Plus
Manual:
Especificaciones
Compatibilidad Controlador Principal | |
---|---|
eeDomus+ | Full Compatible |
Fibaro Home Center 2 v4.160 | Full Compatible |
Fibaro Home Center Lite v.4.160 | Full Compatible |
Vera Edge / Plus / Secure | Not Compatible |
Zipabox/Zipaminicro/ZipaTile | Full Compatible |
Piper / Piper NV (v.1.7.1) | Full Compatible |
Indigo | Full Compatible |
jeedom | Full Compatible |
Z-Wave.me / Z-Way / PoPP Hub | Full Compatible |
Domoticz | Full Compatible |
ZiHome | Full Compatible |
Somfy Tahoma | Full Compatible |
Home Assistant | Full Compatible |
Telldus | Full Compatible |
Tech Data | |
IP Rating | IP 20 |
Alimentación | 1x battery (ER14250) 3,6V |
FLiRS | No |
Explorer Frames - NWI Support | No |
SDK | 6.71.01 |
App Version | HW: 1 FW: 1.01 |
Device Type | Notification Sensor |
Z-Wave Alliance Product Link | https://products.z-wavealliance.org/products/2641 |
Procedimientos | |
Inclusión | 1) Open the cover. 2) Place the device within the direct range of your Z-Wave controller. 3) Set the main controller in add mode (see the controller’s manual). 4) Click the Z-button once or triple click the Z-button quickly, the LED indicator should blink fast. 5) Wait for the adding process to end. 6) Successful adding will be confirmed by the Z-Wave controller’s message. |
Exclusión | 1) Open the cover. 2) Place the device within the direct range of your Z-Wave controller. 3) Set the main controller remove mode (see the controller’s manual). 4) Triple click the Z-button quickly, the LED indicator should blink fast. 5) Wait for the removing process to end. 6) Successful adding will be confirmed by the Z-Wave controller’s message. |
Factory Reset | 1)Power on the device, 2) Press and hold the Z button for more than 20 seconds, 3) If holding time more than 20seconds, the LED indicator will keep on for 2 seconds, which means resetting is complete. 4) The reset feature works only when the device has been included into a Z-Wave network. Use this procedure only in the event that the network primary controller is missing or otherwise inoperable. |
Wake-up (despertar) | Press and hold the Z button for more than 5 seconds and release. |