€ 34.99
Sin Impuesto: € 28.92
Descripción
El detector de movimiento NeoCoolcam viene con un diseño discreto como una pelota y destaca por su alto rango de detección de hasta 7 metros. La instalación es muy fácil gracias a su montaje en pared. Este detector incorpora un sensor de luminosidad.
Además el sensor de movimiento detecta movimiento a una distancia de hasta 7 metros. En combinación con otros dispositivos Z-Wave, el sensor le ayudará a optimizar sus costos de energía al encender las luces automáticamente y también se puede utilizar para escenas de alarma.
Caracteristicas:
- Tecnología inalámbrica: Z-Wave Plus
Rango de detección: 7m
- Ángulo de visión: 90 °
- Volumen de suministro: 1x Sensor de movimiento NEO Coolcam, 1x CR123 (Lithiumbattery), soporte
- Sensor de movimiento con sensor de intensidad de luz (Lux)
- Baterías: 1x CR123
- Duración de la batería: 3 años
- Incluido indicador led con la deteccion de movimiento
Manual:
Especificaciones
Compatibilidad Controlador Principal | |
---|---|
eeDomus+ | Full Compatible |
Fibaro Home Center 2 v4.160 | Full Compatible |
Fibaro Home Center Lite v.4.160 | Full Compatible |
Vera Edge / Plus / Secure | Partially Compatible |
Zipabox/Zipaminicro/ZipaTile | Full Compatible |
Piper / Piper NV (v.1.7.1) | Full Compatible |
Indigo | Full Compatible |
jeedom | Full Compatible |
Z-Wave.me / Z-Way / PoPP Hub | Full Compatible |
Domoticz | Full Compatible |
ZiHome | Full Compatible |
Somfy Tahoma | Full Compatible |
Home Assistant | Full Compatible |
Telldus | Full Compatible |
Tech Data | |
IP Rating | IP20 |
Alimentación | 1x CR123 (Lithiumbattery) |
FLiRS | No |
Explorer Frames - NWI Support | No |
SDK | 6.51.06 |
App Version | HW: 66 FW: 3.80 |
Device Type | Notification Sensor |
Z-Wave Alliance Product Link | https://products.z-wavealliance.org/products/1920 |
Procedimientos | |
Inclusión | 1.Remove the sensor cover. 2.Make sure the sensor is powered. 3.Set Z‐Wave controller or Z‐Wave gateway into inclusion mode (Refer to the controller or gateway operating manual) 4.Press the button three times within 1.5 second, the device will enter inclusion mode. And the LED will flash on and off alternately five times. |
Exclusión | 1.Remove the device cover. 2.Make sure the sensor is powered. 3.Set Z‐Wave controller or Z‐Wave gateway into exclusion mode (Refer to the controller or gateway operating manual) 4.Press the button three times within 1.5 second, the device will enter exclusion mode. |
Factory Reset | Reset procedure will delete all information on the Z‐Wave network and Z‐Wave controller or Z‐Wave Gateway, and restore the sensor to factory default settings. 1.Remove the device cover. 2.Make sure the sensor is powered. 3.Press and hold the button for 10 seconds, Led will blink once. 4.Release the button. Note: to use the reset procedure only when the primary controller is missing or inoperable. |
Wake-up (despertar) | You can press the button once to wake up the device and send wakeup notification to controller. If press successfully, the LED will blink one time |