€ 69.99
Sin Impuesto: € 57.84
Descripción
Este sensor de inundación puede detectar pequeñas cantidades de agua, tan solo 0.5 mm de agua. Esto lo convierte en su primera línea de defensa contra las tuberías dañadas.
Funciones:
- Sensor de inundación inalámbrico Z-Wave Plus
- Protege tu hogar de inundaciones
- Detecta fugas de agua antes de que se conviertan en un problema
- Alertas de una amenaza de inundación, inclinación o cambio de temperatura rápido
- Compatible con cualquier controlador Z-Wave Alimentación de bateríaInformación de batería baja
- Plug-and-play, instalación extremadamente simple
- Se puede usar con una sonda de cable gracias al Dock
CARACTERÍSTICAS TÉCNICAS:
- Fuente de alimentación: batería de litio CR123A 3V / 1500mAh
- Duración de la batería: 2.3 años con configuración predeterminada con eventos de fuga estimados 5 veces al mes
- Radio frecuencia: 868.42 MHz
- Distancia de funcionamiento: hasta 150 metros fuera
- Zumbador máximo del volumen: 60dB a partir de 2 metros
- Sensores: temperatura del aire
- Tipos de notificación admitidos: alarma térmica
- Seguridad en el hogar
- Alarma de agua
- Humedad de funcionamiento: 8% a 80%
Especificaciones
Compatibilidad Controlador Principal | |
---|---|
eeDomus+ | Not Tested |
Fibaro Home Center 2 v4.160 | Not Tested |
Fibaro Home Center Lite v.4.160 | Not Tested |
Vera Edge / Plus / Secure | Not Tested |
Zipabox/Zipaminicro/ZipaTile | Not Tested |
Piper / Piper NV (v.1.7.1) | Not Tested |
Indigo | Not Tested |
jeedom | Not Tested |
Z-Wave.me / Z-Way / PoPP Hub v 3.2.1 | Yes |
Domoticz | Not Tested |
ZiHome | Not Tested |
Somfy Tahoma | Not Tested |
Home Assistant | Not Tested |
Telldus | Not Tested |
Tech Data | |
IP Rating | 65 |
Alimentación | CR123A lithium battery 3V / 1500mAh |
FLiRS | No |
Potencia de carga soportada | No |
Explorer Frames - NWI Support | No |
SDK | 6.51.09 |
App Version | HW: 122 FW: 1.01 |
Device Type | Notification Sensor |
Z-Wave Alliance Product Link | https://products.z-wavealliance.org/products/2437 |
Procedimientos | |
Inclusión | Turn the primary controller of Z-Wave network into inclusion mode, short press the product’s Action Button that you can find on the product. |
Exclusión | Turn the primary controller of Z-Wave network into exclusion mode, short press the product’s Action Button that you can find on the product. |
Factory Reset | Press and hold the Action Button that you can find on the product for 20 seconds and then release. This procedure should only be used when the primary controller is inoperable. |
Wake-up (despertar) | Pressing the Action Button once will trigger sending the Wake up notification command. If press and hold the Z-Wave button for 3 seconds, the Water Sensor will wake up for 10 minutes. |