€ 39.00
Sin Impuesto: € 32.23
Descripción
El sensor de humo Zipato está diseñado para dar aviso cuando se detecta humo. De hecho, cuando detecta humo, se activa una potente alarma acústica y se envía una señal Z-Wave al controlador principal.
Por lo tanto, es posible crear diferentes escenarios desencadenados por esta alerta.
Este detector es un producto Z-Wave Plus y, por lo tanto, soporta todas las características ofrecidas por el chipset de la serie 500.
Un controlador Z-Wave (control remoto, dongle, caja domótica, ...) es necesario para integrar este detector en su red si ya tiene una red existente.
FUNCIONES
- Serie Z-Wave 500
- Alerta audible y Z-Wave en la detección de humo
- Bajo consumo de energía
- Relación automática baja de la batería
- Facilidad de instalación
CARACTERÍSTICAS TÉCNICAS
- Protocolo: Z-wave Plus (868.42MHz)
- Fuente de alimentación: Batería CR123A, 1400mAh
- Voltaje de funcionamiento: 3V
- Corriente de funcionamiento: 90mA
- Rango de temperatura de funcionamiento: -10 ° C a + 50 ° C
- Rango de radio: 30m
- Dimensiones: 60 x 60 x 50mm
- Peso: 132 g
- Normas: EMC 2004/108 / EC, R & TTE 1995/5 / CE, LVD 2006/95 / CE, FCC Parte 15
MANUAL
Especificaciones
Compatibilidad Controlador Principal | |
---|---|
eeDomus+ | Not Tested |
Fibaro Home Center 2 v4.160 | Not Tested |
Fibaro Home Center Lite v.4.160 | Not Tested |
Vera Edge / Plus / Secure | Not Tested |
Zipabox/Zipaminicro/ZipaTile | Full Compatible |
Piper / Piper NV (v.1.7.1) | Not Tested |
Indigo | Not Tested |
jeedom | Not Tested |
Z-Wave.me / Z-Way / PoPP Hub v 3.2.1 | Not Tested |
Domoticz | Not Tested |
ZiHome | Not Tested |
Somfy Tahoma | Not Tested |
Home Assistant | Not Tested |
Telldus | Not Tested |
Tech Data | |
Alimentación | CR123A |
FLiRS | No |
Explorer Frames - NWI Support | No |
SDK | 6.51.08 |
App Version | FW: 1.10 |
Device Type | Notification Sensor / Reporting Sleeping Slave |
Z-Wave Alliance Product Link | https://products.z-wavealliance.org/products/1936 |
Procedimientos | |
Inclusión | - Click [Add] icon in Z-Wave PC Controller Program. - Press the Net_Button 3 times within 1.5s, Green LED is Blinking 3 times within 1 second. - If Inclusion Process is successful, Green led will turn off. |
Exclusión | - Click [Remove] icon in Z-Wave PC Controller Program - Press the Net_Button 3 times within 1.5s - If Exclusion Process is successful, Green led is Blinking 6 times, then turn off. |
Factory Reset | -Long press Net_Button while installing batteries in HS1SA-Z. - Device Reset Locally notification is Transmitted. -Please use this procedure only when the network primary controller is missing or otherwise inoperable. |
Wake-up (despertar) | - Wake up Notification is transmitted every 24 hours by default. - Wake up Notification is transmitted after Notification Report is Transmitted |